A composite comprises a carbonaceous and a metallic nanotube conjugated with a carbonaceous support. The composite may be used to remove contaminants from water.
BACKGROUND: Observational studies have illustrated that maternal central obesity is associated with birth size, including of birth weight, birth length and head circumference, but the causal nature of these associations remains unclear. Our study aimed to test the causal effect of maternal central obesity on birth size and puberty height growth using a Mendelian randomization (MR) analysis. METHODS: We performed two-sample MR using summary-level genome-wide public data. Thirty-five single nucleotide polymorphisms (SNPs), 25 SNPs and 41 SNPs were selected as instrumental variables for waist-to-hip ratio adjusted for BMI, waist circumference adjusted for BMI and hip circumference adjusted for BMI, respectively to test the causal effects of maternal central obesity on birth size and puberty height using an inverse-variance-weighted approach. RESULTS: In this MR analysis, we found no evidence of a causal association between waist circumference or waist-to-hip ratio and the outcomes. However, we observed that one standard deviation (SD) increase in hip circumference (HIP) was associated with a 0.392 SD increase in birth length (p = 1.1 x 10(- 6)) and a 0.168 SD increase in birth weight (p = 7.1 x 10(- 5)), respectively at the Bonferroni-adjusted level of significance. In addition, higher genetically predicted maternal HIP was strongly associated with the puberty heights (0.835 SD, p = 8.4 x 10(- 10)). However, HIP was not associated with head circumference (p = 0.172). CONCLUSIONS: A genetic predisposition to higher maternal HIP was causally associated with larger offspring birth size independent of maternal BMI. However, we found no evidence of a causal association between maternal waist circumference, waist-to-hip ratio and birth size.
Frequency dispersion of the capacitance (C-f) of GaN-based heterostructure are commonly observed at high frequencies. Analytical solutions are derived for frequency dispersion of the heterostructure's capacitance measured on two concentric-circle Schottky contacts, in form of Bessel function, by modeling a distributed network of heterostructure and solving corresponding circular transmission line functions. Solutions reveal C-f is determined by the R-s of 2-D electron gas (2-DEG). So in reverse, the sheet resistance at a certain carrier density can be extracted from the C-f measurement. By fitting experimental C-f data with the model, we obtain a peak mobility of 2044 cm(2)/V.s corresponding to a 2-DEG density of 8.2 x 10(12) cm(-2) and a sheet resistance of 373 Omega/square on an Al0.25Ga0.75N/GaN heterostructure on silicon substrate. The advantage of two Schottky contacts is that they could be implemented by mercury probes with the same geometry, then achieving nondestructive and instant feedback on carrier transport properties and uniformity of as-grown III-V compound semiconductor wafers
Microcredit loans are now common for Inner Mongolian pastoralists and are encouraged by government policy on the basis of their previous success for poverty alleviation. However, the effects of the highly variable weather characteristics of many semiarid rangelands on the efficacy of microcredit have not been fully examined. Pastoralists in our study area are often trapped in a vicious cycle of borrowing more each year to pay for previous debt and the next year’s production. Instead of helping to maintain herds through bad years, microcredit has often led to reduced herds and assets. To understand why, a qualitative, interview-based approach was used to determine the kinds of loans taken out and why they are taken out, as well as to assess household livestock sales, income, and costs in three villages. In poor years, 82% of households used loans to purchase winter forage. However, borrowers sold more livestock because the standard 1-yr loan term, combined with weather and market conditions, often forced sales for repayment. Weather and market variation made annual income and costs difficult to anticipate. Loans became an added household risk, another way that environment can influence the social and economic interactions of a rangeland social-ecological system. Longer-term loans could smooth the uncertainty of weather and market conditions, and supplementary measures such as government subsidies or forage insurance could buffer the inevitable but unpredictable bad years. Globally, study of the impacts of nonequilibrial ecological dynamics on economic and policy institutions would help to understand why many development initiatives have failed in such systems.
In this paper, solubility parameters and minimum miscibility pressures (MMPs) of five tight oil–CO2 systems are calculated in millimeter to nanometer scales. First, the Peng–Robinson equation of state (PR-EOS) is modified to calculate the vapour–liquid equilibrium in nanopores by considering the effects of capillary pressure and shifts of critical temperature and pressure. Second, a thermodynamic formula of the solubility parameter is derived and presented from the modified PR-EOS, which is applied to calculate the solubility parameters in nanopores. Third, the MMPs are estimated from the newly-developed solubility parameter-based method, at which the difference between the solubility parameters of oil and gas phases (Δδ) approximately equals to 3.0(cal/cm3)0.5. The modified PR-EOS is found to be accurate for predicting the oil–CO2 phase behaviour. It is found that Δδ are almost equivalent at low pressures but with the pressure increase, Δδ at a larger pore radius becomes greater. The estimated MMPs are found to agree well with the measured MMPs from the coreflood and slim-tube tests in bulk phase and with the determined MMPs from the diminishing interface method in nanopores, whose average absolute relative deviations (AARD) are within 4.38% except for two abnormal cases. A smaller nanopore is found to contribute to the oil–gas solubility (i.e., a lower Δδ) and the MMP is also decreased with the pore radius. Moreover, the temperature increase and addition of CH4 into the oil and gas phases lead to a larger Δδ, which make the oil and gas phases become more difficult to be soluble so that the corresponding MMPs increase. On the contrary, the oil–gas solubility is beneficial from the addition of C2H6 into gas phase so that the MMP is reduced. Overall, the effects of temperature, initial oil and injection gas compositions on the MMP are found to be weakened in nanopores.
The coating surface temperature of the stealth aircraft increases due to the motion and heating effect, which causes the inhomogeneous temperature distributions between the coating and the metal substrate. In this paper, the millimeter-wave radiation characteristics of the stealth aircraft under motion state are discussed. Firstly, one dimensional heat conduction equation of the stealth aircraft under motion state is established, and we obtain the temperature distributions along the vertical directions. Then, according to the layered coating and th e non-uniformity of diel ectric property caused by temperature variation, the total brightness temperature is calculated by using radiation transfer theory. The calculated results indicate that the temperature distributions of the motional aircraft coating varies with the t ime, and th e millimeter-wave radiation characteristics also have time-varying.
Object matching is critical for updating, maintaining, integrating, and quality assessing spatial data. However, matching data are often obtained from different sources and have problems of positional discrepancy and different levels of detail. To resolve these problems, this article presents a multiscale polygonal object‐matching approach, called the minimum bounding rectangle combinatorial optimization (MBRCO) with spatial district (SD). This method starts with the MBRCO algorithm and its enhancement using the SD to find corresponding MBRs of one‐to‐one, one‐to‐many, and many‐to‐many matching pairs. Then, italigns the MBRs of the matching pairs to identify object matching pairs, which are evaluated using a matching criterion to find geometrically corresponding objects. Our approach was experimentally validated using two topographical datasets at 1:2k and 1:10k. The proposed approach outperforms the common two‐way area overlap method and another method based on the contextual in‐formation and relaxation labeling algorithm. The proposed method achieved accurate aggregation of the many‐to‐many matching pairs under the positional discrepancy scenario.