Objectives: We aimed to study the dynamic changes of hepatitis B virus (HBV) core promoter/precore (CP/preC) sequences during antiviral treatment and their associations with virological responses.
Materials and methods: The baseline and 12-week CP/preC sequences (nts 1655-2014) were obtained from 52 chronic hepatitis B patients with positive hepatitis B e antigen (HBeAg), who received a 104-week lamivudine and adefovir dipivoxil combination therapy. The mutations within the CP/preC were analyzed against genotype specific reference sequences. The nucleotide change rates in individuals during therapy were analyzed in a pairwise comparison manner.
Results: There was no significant difference of the mutation rate at each nucleotide site between baseline and week 12 of treatment (P>0.05). The mutation rates of A1762T/G1764A and G1896A were found to decrease from 46.2% (24/52) at baseline to 36.5% (19/52) at week 12 (P=0.426) and from 28.8% (15/52) to 21.2% (11/52) (P=0.497), respectively. The nucleotide change rates varied from 0.0% - 7.8% in individuals [0.0% in Group 1 (N=26); 0.3% - 7.8% in Group 2 (N=26)] during the first 12-week treatment. HBV DNA levels in Group 2 were significantly lower than those in Group 1 throughout therapy (P<0.01) (e.g., 1.5±1.3log10 IU/ml vs. 2.6±1.0log10 IU/ml at week 104, P=0.001). At week 104 the rates of HBV DNA undetectable and HBeAg loss in Group 2 were significantly higher than those in Group 1 (P<0.05). Along with the increased nucleotide change rates, the rate of HBV DNA undetectable at week 104 tended to increase (odds ratio=0.323, 95% confidence interval=0.138-0.758, P<0.001).
Conclusion: Our findings suggested that the nucleotide changes within HBV CP/preC region during the first 12-week treatment might be associated with a better virological response.
Keywords: Antiviral response; Core promoter; Hepatitis B virus; Mutation; Nucleotide change; Precore.
In 2014, a large, comprehensive field campaign was conducted in the densely populated North China Plain. The measurement site was located in a botanic garden close to the small town Wangdu, without major industry but influenced by regional transportation of air pollution. The loss rate coefficient of atmospheric hydroxyl radicals (OH) was quantified by direct measurements of the OH reactivity. Values ranged between 10 and 20 s(-1) for most of the daytime. Highest values were reached in the late night with maximum values of around 40 s(-1). OH reactants mainly originated from anthropogenic activities as indicated (1) by a good correlation between measured OH reactivity and carbon monoxide (linear correlation coefficient R-2 = 0 : 33) and (2) by a high contribution of nitrogen oxide species to the OH reactivity (up to 30% in the morning). Total OH reactivity was measured by a laser flash photolysis-laser-induced fluorescence instrument (LP-LIF). Measured values can be explained well by measured trace gas concentrations including organic compounds, oxygenated organic compounds, CO and nitrogen oxides. Significant, unexplained OH reactivity was only observed during nights, when biomass burning of agricultural waste occurred on surrounding fields. OH reactivity measurements also allow investigating the chemical OH budget. During this campaign, the OH destruction rate calculated from measured OH reactivity and measured OH concentration was balanced by the sum of OH production from ozone and nitrous acid photolysis and OH regeneration from hydroperoxy radicals within the uncertainty of measurements. However, a tendency for higher OH destruction compared to OH production at lower concentrations of nitric oxide is also observed, consistent with previous findings in field campaigns in China.
In 2014, a large, comprehensive field campaign was conducted in the densely populated North China Plain. The measurement site was located in a botanic garden close to the small town Wangdu, without major industry but influenced by regional transportation of air pollution. The loss rate coefficient of atmospheric hydroxyl radicals (OH) was quantified by direct measurements of the OH reactivity. Values ranged between 10 and 20 s(-1) for most of the daytime. Highest values were reached in the late night with maximum values of around 40 s(-1). OH reactants mainly originated from anthropogenic activities as indicated (1) by a good correlation between measured OH reactivity and carbon monoxide (linear correlation coefficient R-2 = 0 : 33) and (2) by a high contribution of nitrogen oxide species to the OH reactivity (up to 30% in the morning). Total OH reactivity was measured by a laser flash photolysis-laser-induced fluorescence instrument (LP-LIF). Measured values can be explained well by measured trace gas concentrations including organic compounds, oxygenated organic compounds, CO and nitrogen oxides. Significant, unexplained OH reactivity was only observed during nights, when biomass burning of agricultural waste occurred on surrounding fields. OH reactivity measurements also allow investigating the chemical OH budget. During this campaign, the OH destruction rate calculated from measured OH reactivity and measured OH concentration was balanced by the sum of OH production from ozone and nitrous acid photolysis and OH regeneration from hydroperoxy radicals within the uncertainty of measurements. However, a tendency for higher OH destruction compared to OH production at lower concentrations of nitric oxide is also observed, consistent with previous findings in field campaigns in China.
Peroxyacetic acid (PAA, CH3C(O)OOH) plays an important role in atmospheric chemistry, serving as reactive oxidant and affecting radical recycling. However, previous studies revealed an obvious gap between modelled and observed concentrations of atmospheric PAA, which may be partly ascribed to the uncertainty in the kinetics and mechanism of OH-oxidation. In this study, we measured the rate constant of OH radical reaction with PAA (kPAA+OH) and investigated the products in order to develop a more robust atmospheric PAA chemistry. Using the relative rates technique and employing toluene and metaxylene as reference compounds, the kPAA+OH was determined to be (9.4-11.9)*10-12 cm3 molecule-1 s-1 at 298 K and 1 atm, which is about (2.5-3.2) times larger than that parameter used in Master Chemical Mechanism v3.3.1 (MCM v3.3.1) (3.70*10-12 cm3 molecule-1 s-1). Incorporation of a box model and MCM v3.3.1 with revised PAA chemistry represented a better simulation of atmospheric PAA observed during Wangdu Campaign 2014, a rural site in North China Plain. It is found that OH-oxidation is an important sink of atmospheric PAA in this rural area, accounting for ~30% of the total loss. Moreover, the major terminal products of PAA-OH reaction were identified as formaldehyde (HCHO) and formic acid (HC(O)OH). The modelled results show that both primary and secondary chemistry play an important role in the large HCHO and HC(O)OH formation under experimental conditions. There should exist the channel of methyl H-abstraction for PAA-OH reaction, which may also provide routes to HCHO and HC(O)OH formation.
Polarization beam splitters (PBSs) are one of the key components in the integrated photonic circuits. To increase the integration density, various complex hybrid plasmonic structures have been numerically designed to shrink the footprints of the PBSs. Here, to decrease the complexity of the small hybrid structures and the difficulty of the hybrid micro-nano fabrications, the radiation losses are utilized to experimentally demonstrate an ultra-small, broadband, and efficient PBS in a simple bending hybrid plasmonic waveguide structure. The hybrid plasmonic waveguide comprising a dielectric strip on the metal surface supports both the transverse-magnetic (TM) and transverse-electric (TE) waveguide modes. Because of the different field confinements, the TE waveguide mode has larger radiation loss than the TM waveguide mode in the bending hybrid strip waveguide. Based on the different radiation losses, the two incident waveguide modes of orthogonal polarization states are efficiently split in the proposed structure with a footprint of only about 2.2 × 2.2 μm2 on chips. Since there is no resonance or interference in the splitting process, the operation bandwidth is as broad as Δλ = 70 nm. Moreover, the utilization of the strongly confined waveguide modes instead of the bulk free-space light (with the spot size of at least a few wavelengths) as the incident source considerably increases the coupling efficiency, resulting in a low insertion loss of <3 dB.
A simple and environmentally friendly method to synthesize spiropyrazolo[3,4-b]pyridines derivatives starting from isatin, cyclic-1,3-diketone and 3-methyl-5-aminopyrazole was developed. With the optimized conditions for enzymes, solvents, enzyme loading and reaction time in hand, 9 compounds wereobtained in acceptable yields. Moreover, the investigation in fluorescent properties of these products showed their potential application in the field of new fluorescent material.
